- Possessing a particle filter system
To prevent the oil pump from being harmed by large particle pollution, the oil initially flows through an oil suction filter with a filtration precision of 150 um. To safeguard the coalescence separation filter element, the oil is subsequently injected into the high-efficiency filter with a 3um precision. Oil enters the outlet filter for processing after going through the coalescing separator. To make sure that the oil entering the user's fuel tank is as clean as the design aim, 1 μm to 3 μm filter components can be chosen as needed.
- Owning a system that coalesces
The turbine oil purifier receives the pumped-in oil. It first passes through the coalescing filter component. After passing through the coalescing filter element, the free water and emulsified water in the oil coalesced into larger water droplets as a result of the material's distinctive polar molecular structure. Under the influence of gravity, it falls into the water holding tank.
- A system of separation
Oil enters the separation filter element after going through the coalescing filter element. Larger water droplets in the oil had previously dropped beneath the container, while smaller water droplets were still present. The cause is gravity acting as it does. It will rise with the oil till the separation filter element due to inertia. The unique hydrophobic substance that makes up the separation filter element.
Water droplets from outside the filter element are stopped as the oil travels through the separation filter element. The oil first enters the filter element and then exits the liquid port at the same time. The water droplets that are prevented outside the filter element congregate and eventually get bigger. and then, as a result of gravity, fall into the water storage tank located at the bottom of the container.
- A system of automatic drainage
The water storage tank holds the separated water, while the oil-water interface meter measures the distance between the two. The solenoid valve at the base of the water storage tank will open when the height of the interface reaches the specified upper limit value. Following that, the water will be released through the water exit. The solenoid valve will close, halt the drainage, and begin the subsequent cycle once the water level reaches the lower limit setting that has been set.
JT series turbine oil purifier is a suggested turbine oil cleaner.
Here is a turbine oil purifier you might select if you're looking for a superior one. The turbine oil purifier is referred to as the DYJC series. The four functions listed above belong to this lubricant oil purifier. A turbine oil purifier is a device used to filter out lubricating, light, and turbine oils with kinematic viscosities under 46mm2/s. It filters lubricating oil with excellent effectiveness and efficiency. Power plants, power stations, all industrial and mining businesses, etc. are all covered by the lubricating oil purifier.